LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1759 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Front Fender >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Fender Emblem/Nameplate
    GM929507Courtesy of GENERAL MOTORS CORP.
  1. Position the emblem to the fender.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the emblem nut by reaching behind the wheel liner.

    Tighten:  Tighten the nut to 1 N.m (9 lb in).

  3. Install the front wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front in Body Front End.
scientia non olet · About LEMON Manuals