LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1752 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the body surface by wiping with isopropyl alcohol.
    2. Fig 1: Side Hood Seal
    GM930860Courtesy of GENERAL MOTORS CORP.
  2. Remove the protective backing paper from the adhesive on the rear side hood seal.
  3. Install the rear side hood seal.
  4. Close the hood.
scientia non olet · About LEMON Manuals