LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1752 (Body Front End) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the hood latch. Refer to Hood Latch Replacement .
    3. Fig 1: Latch Release Cable
    GM930872Courtesy of GENERAL MOTORS CORP.
  3. Remove the release cable from the structure. Note the routing of the hood cable in the engine compartment for installation.
    4. Fig 2: View Of Center Pillar Lower Garnish Molding
    GM965599Courtesy of GENERAL MOTORS CORP.
  4. Inside the vehicle, remove the left front carpet retainer. Refer to Carpet Retainer Replacement - Front in Interior Trim.
  5. Push carpet aside to expose release handle.
    6. Fig 3: Hood Hinge Cable
    GM930888Courtesy of GENERAL MOTORS CORP.
  6. Pull release handle to up position.
  7. Pry back front of handle slip to disengage from the hinge pillar.
  8. Remove the hood hinge cable grommet from the front of the dash and remove the cable from the core support.
scientia non olet · About LEMON Manuals