LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1751 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inside Of Trim Panel
    GM980931Courtesy of GENERAL MOTORS CORP.
  1. Position the liftgate trim hook over the wiper motor assembly. Slide the trim into position.
  2. While holding the liftgate trim away from the structure, connect the liftgate lamp harnesses to the lamps.
    3. Fig 2: Location Of Trim Retainers
    GM977555Courtesy of GENERAL MOTORS CORP.
  3. Position the liftgate to the structure and snap into place.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the fasteners.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals