LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1751 (Body Rear End) >> Repair Instructions >> Strut Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
    Fig 1: Identifying Lift Gate Support Strut
    GM930678Courtesy of GENERAL MOTORS CORP.
  1. Open and support the lift gate.
    2. IMPORTANT: Spring clips should not be removed from struts.
  2. Lift up and partially remove the spring clips on the strut using a small flat-bladed tool.
  3. Remove the upper end of the strut from the ball joint.
  4. Remove the lower end of the strut from the ball joint.
  5. Remove the strut from the lift gate.
scientia non olet · About LEMON Manuals