LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1751 (Body Rear End) >> Repair Instructions >> Strut Ball Stud Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Body Side Strut Anchor
    GM930701Courtesy of GENERAL MOTORS CORP.
  1. Install the body side strut anchor.
  2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Tighten the lift gate to body strut anchor bolts.

    Tighten:  Tighten the strut anchor bolts to 10 N.m (89 lb in).

  4. Fig 2: Lift Gate Side Strut Anchor
    GM930695Courtesy of GENERAL MOTORS CORP.
  5. Tighten the lift gate strut anchor.

    Tighten:  Tighten the lift gate strut anchor to 25 N.m (18 lb ft).

  6. Install the lift gate struts. Refer to Strut Replacement - Liftgate