LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1750 (Interior Trim) >> Repair Instructions >> Windshield Upper Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the windshield upper garnish molding to the top of the instrument panel. Align the molding to the body structure.
    2. IMPORTANT: If the vehicle is equipped with a side inflator module, position the module tether rearward of the molding attaching clips.
  2. Gently push at the clip locations to install the garnish molding.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the fastener.

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

  4. Install the fastener plug to the garnish molding.
  5. Replace the door seal over the edge of the garnish molding.
scientia non olet · About LEMON Manuals