Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Upper Fastener Cover & Shoulder Belt

Courtesy of GENERAL MOTORS CORP.

Unsnap the cover on the rear seat shoulder belt to expose the shoulder belt fastener.
Remove the shoulder belt fastener and the shoulder belt.

Fig 2: Lock Pillar Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Lower the rear seat back.
Partially remove the lock pillar garnish molding by gently pulling at the clip locations.

Fig 3: Side Trim Panel

Courtesy of GENERAL MOTORS CORP.

Partially remove the side trim panel at the lock pillar garnish molding location.

Fig 4: Lock Pillar Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Partially remove the front upper section of the side trim panel. Squeeze the lock pillar molding to gain access to the headliner. Remove the molding.