LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1750 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Lock Pillar Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lock Pillar Garnish Molding
    GM987370Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Position the lock pillar molding to the side trim.
  2. Align the locator pin on the molding to the structure.
  3. Install the lock pillar garnish molding by pushing gently at the clip locations.
    4. Fig 2: Side Trim Panel
    GM987649Courtesy of GENERAL MOTORS CORP.
  4. Install the side trim panel.
    5. Fig 3: Upper Fastener Cover & Shoulder Belt
    GM964659Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the rear seat shoulder belt to the rear lock pillar.

    Tighten:  Tighten the belt fastener to 50 N.m (37 lb ft).

  6. Snap the shoulder belt cover over the fastener.
  7. Raise the rear seat back.
  8. Test the rear seat shoulder belt to ensure proper operation.
  9. Install the door seal over the edge of the garnish molding.
scientia non olet · About LEMON Manuals