LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1750 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Center Pillar Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Molding
    GM977169Courtesy of GENERAL MOTORS CORP.
    CAUTION: Striking the vehicle near the side air bag impact sensor can cause an air bag deployment if the ignition switch is not OFF. To help avoid personal injury and damage to the vehicle from a deployment. Always turn the ignition switch OFF during body repairs.
  1. Position the molding to the frame.
  2. Push at the clip locations to secure the attaching clips.
  3. Position the weatherstrip over the edge of the garnish molding.
    4. Fig 2: View Of Center Pillar Lower Garnish Molding
    GM965599Courtesy of GENERAL MOTORS CORP.
  4. Install the hinge pillar garnish molding.
  5. Install the rear carpet retainer. Refer to Carpet Retainer Replacement - Rear .
  6. Install the center pillar upper molding. Refer to Garnish Molding Replacement - Center Pillar Upper .
  7. Position the weatherstrip over all of the moldings.
  8. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
scientia non olet · About LEMON Manuals