LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1748 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Shift Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Control Lever Assembly, Bracket & Nuts
    GM1159589Courtesy of GENERAL MOTORS CORP.
  1. Install the control lever assembly to the control lever assembly bracket.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the control lever nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    3. Fig 2: Aligning Shifter Neutral Lock Clip
    GM873345Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift cables to the control lever assembly.
  4. With the shift cable ends in the adjusters, adjust the cables by pushing the shifter neutral lock clip. Move the shifter slightly to center the lock clip.
    5. IMPORTANT: Ensure the transaxle is in NEUTRAL.
  5. Press and lock the shift cable retainers.
  6. Pull the shifter neutral lock clip to the original position.
    7. Fig 3: Electrical Connectors & Window Switch Trim Bezel
    GM1159558Courtesy of GENERAL MOTORS CORP.
  7. Connect the electrical connectors.
  8. Connect the shift cables to the control lever assembly.
  9. Install the trim bezel.
  10. Install the control assembly boot to the trim bezel.
scientia non olet · About LEMON Manuals