Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shift Cable Pass-Through Grommet

Courtesy of GENERAL MOTORS CORP.

Install the shift cables from the interior of the vehicle to the underhood area. Ensure that the shift cable pass-through grommet is properly seated and the grommet arrow is pointing up.
Replace the carpeting at the front of the dash.
Install the right side console trim panel.

Fig 2: Shift Cables & Control Lever Assembly Housing

Courtesy of GENERAL MOTORS CORP.

Connect the shift cables to the control lever assembly.
With the shift cable ends in the adjusters, adjust the cables by pushing the shifter neutral lock clip. Move the shifter slightly to center the lock clip.

IMPORTANT: Ensure the transaxle is in NEUTRAL.

Press and lock the shift cable retainers.
Pull the shifter neutral lock clip to the original position.

Fig 3: Electrical Connectors & Window Switch Trim Bezel

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors.
Install the trim bezel.
Install the control assembly boot to the trim bezel.

Fig 4: Cable Retainer & Steering Gear Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: New cable clips must be used to ensure proper retention.

Clip the cables to the steering gear assembly.
Connect the shift cables to the shift cable bracket.

Fig 5: View Of Shift Cables, Cable Connections & Shift Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Connect the shift cable ends to the transaxle.