LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1748 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Shift Cable Adjustment

Shift Cable Adjustment

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connectors & Window Switch Trim Bezel
    GM1159558Courtesy of GENERAL MOTORS CORP.
  1. Set the parking brake and shift the transaxle to NEUTRAL.
  2. Disconnect the control assembly boot trim from the trim bezel.
  3. Gently pry up the window switch trim bezel.
  4. Disconnect the electrical connectors from the window switch trim bezel and remove the bezel.
    5. Fig 2: Aligning Shifter Neutral Lock Clip
    GM873345Courtesy of GENERAL MOTORS CORP.
  5. Lift the shift cable adjuster retainers.
  6. Adjust the cable by pushing the shifter neutral lock clip. Move the shifter slightly in order to center the lock clip.
    7. Fig 3: Shift Cables & Control Lever Assembly Housing
    GM1472902Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the transaxle is in NEUTRAL.
  7. Press and lock the shift cable retainers.
  8. Pull the shifter neutral lock clip to the original position.
    9. Fig 4: Electrical Connectors & Window Switch Trim Bezel
    GM1159558Courtesy of GENERAL MOTORS CORP.
  9. Connect the electrical connectors.
  10. Install the bezel.
  11. Connect the control assembly boot trim to the bezel.
scientia non olet · About LEMON Manuals