LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1747 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Multifunction Lever
    GM928835Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
  2. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .
  4. Remove the SIR coil. Refer to SIR COIL ASSEMBLY in Air Bag Restraint Systems.
  5. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  6. Depress the lock tabs on the left and right multifunction levers. Remove the multifunction levers.
    7. Fig 2: View Of Ignition Housing Electrical Connectors
    GM928832Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the housing electrical connectors.
    8. Fig 3: View Of Lock Housing Bolts
    GM928840Courtesy of GENERAL MOTORS CORP.
  8. Remove the lock housing bolts.
  9. Separate the ignition housing from the multifunction lever bracket. Slide the bracket from the column.
scientia non olet · About LEMON Manuals