Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Vehicle must be in PARK prior to ignition cylinder removal.

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .

Fig 1: Key & Ignition Lock Cylinder

Courtesy of GENERAL MOTORS CORP.

Insert key into the ignition and rotate to the RUN position. Then rotate ignition cylinder back to ACC position.

Fig 2: Locking Button On Side Of Ignition Module Assembly

Courtesy of GENERAL MOTORS CORP.

Depress the locking button through hole on side of ignition module assembly with a thin pick-type tool. Slide the lock cylinder from the ignition housing.