LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1746 (Wiper System And Washer System) >> Repair Instructions >> Washer Pump/Reservoir Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Washer Pump/Reservoir
    GM931356Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Allow the coolant surge tank sufficient cooling time before handling.
  1. Remove the coolant surge tank bolts.
    2. IMPORTANT: Do not disconnect the coolant hoses from the coolant surge tank.
  2. Disconnect the surge tank level sensor and set surge tank aside in engine compartment.
  3. Remove the front washer solvent container bolts.
    4. Fig 2: Washer Solvent Filter Grommet
    GM929316Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the front washer solvent container hose from the front washer nozzle hose that runs along the upper motor compartment rail.
  5. Angle the washer solvent container to the rear of the vehicle and pull out of the mounting hole.
  6. Disconnect the washer pump electrical connector.
    7. IMPORTANT: Contain any solvent the may spill while removing pump and hoses.
  7. Pull the washer solvent pump from the solvent container.
  8. Disconnect the front and rear washer solvent hoses from the washer pump.
scientia non olet · About LEMON Manuals