LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Roof) >> Repair Instructions >> Sunroof Window Height and Opening Fit Adjustment

Sunroof Window Height and Opening Fit Adjustment

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Correct adjustment cannot be achieved if the sunroof window is closed from vent position.
  1. Cycle the sunroof window from full open to closed position.
    2. Fig 1: View Of Sunroof Window & Opening Fit
    GM977336Courtesy of GENERAL MOTORS CORP.
  2. Loosen the adjusting screws.
  3. Adjust the corners of the glass panel using the following guidelines:
    • Adjust the front of the sunroof window flush to 1 mm (0.04 in) below the top surface of the roof panel.
    • Adjust the rear of the sunroof window flush to 1 mm (0.04 in) above the top surface of the roof panel.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the sunroof window adjustment screws.

    Tighten:  Tighten the sunroof window adjusting screws to 6 N.m (53 lb in).

  5. Cycle sunroof window through all positions.
  6. Inspect the sunroof window adjustment. Adjust if necessary.
scientia non olet · About LEMON Manuals