LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Seat Belts) >> Repair Instructions >> Seat Belt Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat assembly. Refer to Seat Replacement - Rear in Seats.
  2. Fig 1: Cargo Hooks
    GM980988Courtesy of GENERAL MOTORS CORP.
  3. Remove the cargo hooks.
  4. Fig 2: Load Floor Storage Bin
    GM977535Courtesy of GENERAL MOTORS CORP.
  5. On the driver side, remove the load floor storage bin.
  6. Fig 3: Rear Load Floor Lock Lever
    GM987444Courtesy of GENERAL MOTORS CORP.
  7. Remove the rear load floor. If the vehicle is equipped with a lock lever, move the lever inboard and lift up on the load floor.
  8. Fig 4: Disconnecting Accessory Wire Harness
    GM965660Courtesy of GENERAL MOTORS CORP.
  9. Remove the rear wheel quarter trim panel by pulling at the attaching clip locations.
  10. On the driver side, disconnect the auxiliary plug wire harness connection.
  11. Fig 5: Shoulder Belt Fastener
    GM965560Courtesy of GENERAL MOTORS CORP.
  12. Remove the shoulder belt fastener at the floor.
  13. Fig 6: Retractor Fastener
    GM964651Courtesy of GENERAL MOTORS CORP.
  14. Remove the retractor fastener and remove the retractor.
  15. Fig 7: Upper Fastener Cover & Shoulder Belt
    GM964659Courtesy of GENERAL MOTORS CORP.
  16. Unsnap the upper fastener cover and remove the shoulder belt upper fastener. Remove the shoulder belt assembly.