LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Seat Belts) >> Repair Instructions >> Seat Belt Replacement - Front (Quick Connect) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Retractor Fastener
    GM965575Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply Permatex® 24200 on all restraint fasteners prior to installation.
  1. Position the shoulder belt retractor into the center pillar positioning unit with the locking tab in the body structure notch.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the retractor fastener.

    Tighten:  Tighten the fastener to 45 N.m (33 lb ft).

  3. Snap the shoulder belt webbing retainer into the center pillar.
  4. Install the lower garnish molding into the center pillar. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
    5. Fig 2: Shoulder Belt Assembly & Front Seat Mini-Belt Buckle
    GM977250Courtesy of GENERAL MOTORS CORP.
  5. Install the seat belt to the seat assembly.
scientia non olet · About LEMON Manuals