Conditions for Clearing the MIL/DTC

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

A current DTC will clear on the next consecutive malfunction free ignition cycle.
A history DTC will clear after 100 consecutive malfunction free ignition cycles.
Using a scan tool

DTC C0848

Step	Action	Yes	No
Connector End Views Reference: Power Steering System Connector End Views
1	Did you perform the Power Steering Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Power Steering System
2	Test the ignition 1 voltage circuit for a short to voltage. Refer to Testing for a Short to Voltage and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC. Does the DTC reset?	Go to Step 2	System OK