Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- The BCM no longer detects an open in the security indicator control circuit.
- A scan tool is used to clear the DTC.
DTC B0689
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check-Theft Deterrent? | Go to Step 2 | Go to Diagnostic System Check - Theft Deterrent |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 6 | Go to Step 4 |
| 4 | Test for an open or short to ground in the security indicator control circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages, and Console. Did you complete the replacement? |
Go to Step 9 | - |
| 8 |
IMPORTANT:
The BCM programming and setup procedure must be performanced when replacing the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration
in Body Control System. Replace the BCM. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 1 |