LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Seats) >> Repair Instructions >> Seat Cushion Heater Element Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Seat Cushion Heater Element
    GM987804Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the back of the heater element.
  2. Position the heater element over the seat foam pad. Press firmly to engage the adhesive.
  3. Route the heating element wiring harness under the seat pad and connect the harness to the heater module. Secure the wire with tie straps.
  4. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front .
  5. Install the front seat to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals