LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Seats) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Cover & Pad
    GM986588Courtesy of GENERAL MOTORS CORP.
  1. Install the trim cover to the pad. Engage the hook and loop locations by pressing firmly.
  2. Position the seat cushion cover and pad to the frame.
  3. Tuck the seat cushion cover into the seat belt buckle opening.
  4. Insert the anchor plates for the seat belt buckle through the cushion.
  5. Attach the cushion cover retainers to the seat frame.
  6. Pull on the drawstring and connect the drawstring retainer to the cushion frame.
    7. Fig 2: Rear Seat Fasteners
    GM977275Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Install the anchor bolts to the rear seat buckle.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  8. Install the rear seat. Refer to Seat Replacement - Rear .
scientia non olet · About LEMON Manuals