Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning Seat Cushion Pad To Frame

Courtesy of GENERAL MOTORS CORP.

Position the seat cushion pad to the frame.
Engage the hook and loop retainers by pressing down on the retainers.
Engage the J-strip at the rear of the cushion cover to the seat pan.
On vehicles with a J-hook design, connect the J-hook retainers.

Fig 2: Drawstring Clips

Courtesy of GENERAL MOTORS CORP.

On vehicles with a drawstring design, connect the drawstring clips.

Fig 3: Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Position the seat cushion pan over the seat adjusters.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the frame bolts.
Tighten: Tighten the bolts to 12 N.m (9 lb ft).

Fig 4: Connecting Heat Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

For vehicles with heated seats connect the heat module electrical connector.
If the seat is equipped with a lumbar support, perform the following procedure:
1. Pull the lumbar cable sleeve forward.
2. Using a sharp-bladed tool, make a small slit where the lumbar actuator meets the cover.
3. Install the lumbar knob by pushing firmly.
4. Adjust the lumbar knob to ensure that the lumbar is operating correctly.
Install the front seat into the vehicle. Refer to Seat Replacement - Front Bucket .