Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Cable Out Of Seat Back Assembly

Courtesy of GENERAL MOTORS CORP.

If you are replacing the cable, route the cable through the rear seat back.

Fig 2: Disconnecting/Connecting Seat Recliner Cable

Courtesy of GENERAL MOTORS CORP.

Connect the latch cable to the recliner mechanism.

Fig 3: Seat Back Recliner Handle & Cable

Courtesy of GENERAL MOTORS CORP.

Connect the J-strip at the bottom of the seat cover.
Connect the latch cable to the latch assembly.

Fig 4: Installing Fastener From Rear Seat Back Latch

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the latch to the seat back with a fastener.
Tighten: Tighten the fastener to 2.5 N.m (22 lb in).