LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Seats) >> Repair Instructions >> Seat Back Heater Element Replacement - Front (Non-Fold Flat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Element From Seat Back Pad
    GM987728Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the back side of the heater element.
  2. Position the heater element over the seat foam pad. Press firmly to engage the adhesive.
  3. Lower the seat back trim cover, pressing on the hook and loop retainers in order to engage the retainers.
    4. Fig 2: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  4. Connect the lower J-hook retainer to the seat back trim.
  5. Connect the electrical connector to the heater element module.
  6. Install the armrest to the seat. Refer to Armrest Replacement - Front Seat .
  7. Install the outer trim panel to the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (4-Way)  or Seat Cushion Outer Trim Panel Replacement - Front Seat (2-Way) .
  8. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals