LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Seats) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front (Non-Fold Flat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Headrest Guides
    GM981023Courtesy of GENERAL MOTORS CORP.
  1. Position the seat back pad on the frame.
  2. Install the seat back trim cover over the top of the seat back.
  3. Install the head restraint guides by pressing the guides into position until the locking tabs engage.
    4. Fig 2: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  4. Continue installing the seat back trim cover, pressing over the hook and loop locations to ensure that the hooks engage.
  5. Connect the J-hook retainer to the seat back trim cover.
  6. Install the head restraint. Refer to Head Restraint Replacement - Front Seat .
    7. Fig 3: Connecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  7. On vehicles with heated seats, connect the electrical connector to the seat heat module.
  8. Install the armrest to the seat. Refer to Armrest Replacement - Front Seat .
  9. Install the side trim panel to the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (4-Way)  or Seat Cushion Outer Trim Panel Replacement - Front Seat (2-Way) .
  10. Install the seat into the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals