LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Seats) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front (Fold Flat) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. Refer to Seat Replacement - Front Bucket .
    2. Fig 1: View Of Front Seat Back Recliner Trim Panel
    GM981031Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the outboard recliner trim panel. Remove the trim panel.
    3. Fig 2: Inboard Recliner Trim Panel
    GM981057Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the inboard recliner trim panel. Remove the trim panel.
    4. Fig 3: Inserting Small Pin Into Head Restraint Escutcheon
    GM986780Courtesy of GENERAL MOTORS CORP.
  4. Position the head restraint to the full up position.
  5. Insert an awl into the head restraint guide hole and push in on the awl while pulling up on the restraint. Remove the head restraint.
    6. Fig 4: Disconnecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  6. On vehicles with heated seats disconnect the heated seat wire harness from the seat heat module.
  7. Remove the bolts from the front seat back frame.
  8. Remove the seat back assembly.
    9. Fig 5: Removing Screws At Seat Back Panel
    GM981048Courtesy of GENERAL MOTORS CORP.
  9. Remove the screws from the seat back panel.
  10. Remove the seat back panel.
  11. Remove the armrest from the seat back. Refer to Armrest Replacement - Front Seat .
    12. Fig 6: View Of Lower J-Hook Retainer
    GM981476Courtesy of GENERAL MOTORS CORP.
  12. Disconnect the lower J-hook retainer from the seat back trim cover.
  13. Pull the seat back cover upward. Carefully disengage the hook and loop fasteners until the head restraint guides are exposed.
    14. Fig 7: Removing/Installing Headrest Guides
    GM981023Courtesy of GENERAL MOTORS CORP.
  14. Squeeze the locking tabs on the head restraint guides and push the guides up and out of the seat back frame.
  15. Remove the seat back trim cover from the seat.
  16. Remove the seat back pad from the frame.
scientia non olet · About LEMON Manuals