Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lumbar Actuator

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the lumbar actuator to the seat cushion frame with screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Lumbar Knob

Courtesy of GENERAL MOTORS CORP.

Install the lumbar knob.
Install the lumbar cable in the actuator:
1. Pull back on the lumbar cable sleeve.
2. Install the barrel end of the cable from the lumbar actuator.
3. Adjust the knob to ensure that the cable is properly installed.
Install the front seat. Refer to Seat Replacement - Front Bucket .