Test Description
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: This DTC detects an open stop lamp switch signal circuit from the stop lamp side of the splice pack to the EBCM.
- 4: The EBCM sources 5 volts on the stop lamp switch signal circuit. This small voltage has a ground path through the stop lamp bulbs. This DTC sets if the path to ground is open.
DTC C0161
| Step | Action | Yes | No |
|---|---|---|---|
| Connector End View Reference: ABS Connector End Views or Lighting Systems Connector End Views in Lighting Systems | |||
| 1 | Did you perform the antilock brake system (ABS) Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 |
|
Go to Step 4 | Go to Step 3 |
| 3 | Test the signal circuit of the stop lamp switch for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 4 | Press the brake pedal. Are all of the stop lamps OFF? |
Go to Step 5 | Go to Diagnostic Aids |
| 5 | Test the feed circuit of the stop lamps for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 6 | Test the ground circuit of the stop lamps for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Diagnostic Aids |
| 7 | Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 8 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 9 |
|
Go to Step 2 | System OK |