High Beam Indicator Inoperative
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
High Beam Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics | |||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 6 |
| 4 | Inspect the high beam indicator bulb for an open filament. Did you find an inoperative bulb? |
Go to Step 8 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 7 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
Go to Step 10 | - |
| 8 | Replace the high beam indicator bulb. Refer to Instrument Cluster Lamp Replacement
in Instrument Panel, Gages, and Console. Did you complete the replacement? |
Go to Step 10 | - |
| 9 |
IMPORTANT:
Perform the set up procedure for the body control module. Replace the BCM. Refer to Body Control Module Replacement
in Body Control Systems.Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |