Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Temperature Cable Knob & Shaft

Courtesy of GENERAL MOTORS CORP.

Position the center trim bezel in the vehicle.
Center the temperature cable knob by inserting the alignment tab into the centering slot of the temperature knob shaft.

Fig 2: Aligning Cable Lug With Center Point Detent Spring

Courtesy of GENERAL MOTORS CORP.

Center the HVAC module temperature door by aligning the cable lug of the temperature control cable with the center point detent spring.

Fig 3: HVAC Control Module Connectors

Courtesy of GENERAL MOTORS CORP.

Install the temperature cable to the HVAC control head by aligning the snap tabs to the knob shaft and by snapping into place.
Connect the other control head connectors.

Fig 4: Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the bezel mounted switches.

Fig 5: Push To Engage Trim Bezel Clips

Courtesy of GENERAL MOTORS CORP.

Starting at the top of the bezel, push to engage the trim clips.

Fig 6: Center Storage Compartment Screws

Courtesy of GENERAL MOTORS CORP.

Position the I/P storage compartment.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the storage compartment screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .