LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1727 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Lens Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Cluster Assembly
    GM881128Courtesy of GENERAL MOTORS CORP.
  1. Hold the lens/mask assembly face up by the ends and align the reset knob with the hole in the lens.
  2. Align the tabs and the slots between the assembly and the housing.
  3. Press down on top of the assembly around the edges to fully seat all clips.
  4. Inspect that all gages and clips are seated correctly and that no debris or markings are on the lens or the dial faces.
  5. Install the I/P cluster assembly. Refer to Instrument Panel Cluster (IPC) Replacement .
scientia non olet · About LEMON Manuals