Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Console Trim Panels

Courtesy of GENERAL MOTORS CORP.

Position the right console trim panel.
Install the push-in fastener.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the screws to the right console trim panel.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) .

Fig 2: Center Trim Plate

Courtesy of GENERAL MOTORS CORP.

Position the center trim plate to the front console.
Push until the trim clips engage.
Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .

Fig 3: View Of Auxiliary Power Outlet Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Lift the rear of the center floor console.
Connect the electrical connector to the auxiliary power outlet.
Reposition the center console.

Fig 4: Removing/Installing Cup Holder Liner

Courtesy of GENERAL MOTORS CORP.

Install the cup holder screw.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the cup holder liner.

Fig 5: Locating Console Screws

Courtesy of GENERAL MOTORS CORP.

Reach under the front seats to access the lower console screws.
Install the center console screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Position the front seat forward to the original position.