LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1727 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Console Replacement - Front Floor >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Auxiliary Power Outlet Electrical Connector
    GM1194731Courtesy of GENERAL MOTORS CORP.
  1. Position the console between the front bucket seats.
  2. Connect the electrical connector to the auxiliary power outlet.
  3. Reposition the center console.
    4. Fig 2: Removing/Installing Cup Holder Liner
    GM1171184Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the cup holder screw.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  5. Install the cup holder liner.
    6. Fig 3: Locating Console Screws
    GM1152195Courtesy of GENERAL MOTORS CORP.
  6. Reach under the front seats to access the lower console screws.
  7. Install the center console screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  8. Position the front seat forward to the original position.
scientia non olet · About LEMON Manuals