LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1726 (Engine Cooling) >> Repair Instructions >> Hoses and Clamps Inspection >> Hose Replacement

Hose Replacement

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Slitting Hose End
    GM895319Courtesy of GENERAL MOTORS CORP.
  1. Stop the engine.
  2. Drain the coolant. Refer to Draining and Filling Cooling System 
  3. Slit the hose end, twist left and right and pull straight off for easy removal.
    4. Fig 2: Sliding Clamp To Within 3 mm (0.12 In) Of Hose End
    GM893865Courtesy of GENERAL MOTORS CORP.
  4. Clean off the outlets with a clean cloth. Use sandpaper if necessary.
  5. Dip the ends of the new hose into coolant for easier installation.
  6. Install clamps on the hose (1).
  7. Install the hose (2) onto the nipple (3) until the hose contacts the hose stop bead (4). The white line on the hose should be at the 12 o'clock position.
  8. Slide the clamp (1) to within 3 mm (0.12 in) of the hose end.
  9. Install the pressure tester on the bottle and check for leaks.
  10. Fill the cooling system. Refer to Coolant Replacement in this section of the service manual.
scientia non olet · About LEMON Manuals