LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1724 (Wiring Systems (General Information)) >> Repair Instructions >> Underhood Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Connectors Into Proper Location
    GM935000Courtesy of GENERAL MOTORS CORP.
  1. Install each of the following 68-way connectors into its proper location.
    • Fuse block case (1)
    • Forward lamp 68-way connector (2)
    • Engine 68-way connector (3)
    • IP 68-way connector (4)
  2. Push down on each connector until it is fully secured into the fuse block.
    3. Fig 2: Locating Underhood Fuse Block (UHFB) Fuse Cover
    GM934982Courtesy of GENERAL MOTORS CORP.
  3. Connect the IP connectors (2)
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Tighten the bolts (1) on the top of the fuse block.

    Tighten:  Tighten the underhood accessory wiring junction block harness retaining bolts (1) to 4 N.m (35 lb in).

    5. Fig 3: Removing/Installing Underhood Electrical Wiring
    GM934966Courtesy of GENERAL MOTORS CORP.
  5. Reconnect the positive battery cable and EPS at the end of the fuse block with the nut.

    Tighten:  Tighten the positive battery cable nut to 17 N.m (13 lb ft).

  6. Install the fuse box cover.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
scientia non olet · About LEMON Manuals