LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1724 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Fuse Block & Attached Ground Wire & Bolt
    GM934747Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the fuse block and attach the ground wire (1) and attach the bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Removing/Installing Harness Connectors
    GM1232488Courtesy of GENERAL MOTORS CORP.
  2. Connect the harness connectors to the back of the I/P fuse block (4).

    Tighten:  Tighten the connectors to 4 N.m (35 lb in).

  3. Install the console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  4. Connect the positive battery cable.

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  5. Connect the negative battery cable.

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  6. Install the battery cooling box cover and install the screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  7. Set the radio stations to the preset selections.
scientia non olet · About LEMON Manuals