LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1722 (Bumper System) >> Repair Instructions >> Step Pad Replacement - Rear Bumper (Center) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Backing From Adhesive Strips
    GM755560Courtesy of GENERAL MOTORS CORP.
  1. Remove the backing from the adhesive strips.
  2. Position the step pad to the fascia.
  3. Install the step pad to the fascia, ensuring that the retaining tabs are thoroughly engaged, and the end of the step pad are secured.
  4. Close the liftgate.
scientia non olet · About LEMON Manuals