LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1722 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spare tire carrier. Refer to TIRE HOIST AND SHAFT REPLACEMENT in Tires and Wheels.
  2. Remove the rear fascia. Refer to Fascia Replacement - Rear Bumper .
    3. Fig 1: Disconnecting Trailer/Towing Receptacle Electrical Connector
    GM752485Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the trailer/towing receptacle electrical connector.
  4. Rotate the trailer/towing receptacle assembly counterclockwise and remove from the vehicle.
    5. Fig 2: Removing 4 Rearward Bolts That Retaining Impact Bar Assembly
    GM752281Courtesy of GENERAL MOTORS CORP.
  5. Remove the 4 rearward bolts that retain the impact bar assembly to the frame rails.
  6. While an assistant holds the impact bar (1) assembly in place, remove the remaining 2 retaining bolts.
  7. Remove the impact bar (1) assembly from the vehicle with an assistant.
scientia non olet · About LEMON Manuals