LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1722 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Impact Bar Assembly To Vehicle
    GM752281Courtesy of GENERAL MOTORS CORP.
  1. Position the impact bar (1) assembly to the vehicle with an assistant.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the bolts that retain the rear impact bar to the frame.

    Tighten:  Tighten the rear impact bar bolts to 364 N.m (268 lb ft).

    3. Fig 2: Installing Trailer/Towing Receptacle Assembly To Bracket
    GM752485Courtesy of GENERAL MOTORS CORP.
  3. Install the trailer/towing receptacle assembly to the bracket and rotate clockwise until fully seated.
  4. Connect the trailer/towing receptacle electrical connector.
  5. Install the rear fascia. Refer to Fascia Replacement - Rear Bumper .
  6. Install the spare tire carrier. Refer to TIRE HOIST AND SHAFT REPLACEMENT in Tires and Wheels.
scientia non olet · About LEMON Manuals