LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1722 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tow hooks to the impact bar. Refer to Tow Hook Replacement - Front (Chevrolet (X88) ONLY) in Frame and Underbody.
    2. Fig 1: Positioning Impact Bar To Frame
    GM740662Courtesy of GENERAL MOTORS CORP.
  2. Position the impact bar (3) to the frame (2).
    3. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  3. Install the bolts (1) that retain the impact bar to the frame.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

    4. Fig 2: View Of Fascia-To-Fascia Support Rod Push-Pins
    GM740663Courtesy of GENERAL MOTORS CORP.
  4. Position the fascia support rods (2) to the impact bar (5).
  5. Install the bolts (2) which retain the fascia support rods to the impact bar.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the front fascia. Refer to Fascia Replacement - Front Bumper (Chevrolet, GMC)  or Fascia Replacement - Front Bumper (Oldsmobile) .
scientia non olet · About LEMON Manuals