Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning Fascia To Vehicle Impact Bar

Courtesy of GENERAL MOTORS CORP.

Position the fascia to the vehicle impact bar.

NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .

Install the upper retaining bolts to the fascia.
Tighten: Tighten the bolts to 2.5 N.m (22 lb in).

Fig 2: Installing Screws Retaining Fascia To Wheelhouse Flanges

Courtesy of GENERAL MOTORS CORP.

Install the screws that retain the fascia to the wheelhouse flanges.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: Installing And Fully Seating Lower Push-Pins

Courtesy of GENERAL MOTORS CORP.

Install and fully seat the lower push-pins.
Install the backup lamp socket assemblies, if applicable. Refer to BACKUP LAMP REPLACEMENT (GMC) in Lighting Systems.