LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1722 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper (Oldsmobile) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Bumper Fascia
    GM740666Courtesy of GENERAL MOTORS CORP.
  1. Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
  2. Install the 4 push-pins that retain the bottom of the fascia to the air dam.
    3. Fig 2: View Of Fascia-To-Fascia Support Rod Push-Pins
    GM740663Courtesy of GENERAL MOTORS CORP.
  3. Install the push-pins (3) that retain the fascia to the fascia support rods (2).
  4. Install the air deflector to the fascia. Refer to Air Deflector Replacement - Front Bumper Fascia .
  5. Install the cornering lamps. Refer to CORNERING LAMP REPLACEMENT in Lighting Systems.
  6. Install the fog lamps. Refer to FOG LAMP REPLACEMENT - FRONT (GMC/CHEVROLET) or FOG LAMP REPLACEMENT - FRONT (OLDSMOBILE) in Lighting Systems.
  7. Lower the vehicle.
    8. Fig 3: Identifying Center Fascia Push-Pins
    GM740665Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  8. Install the 2 bolts that retain the top of the fascia to the headlamp panel assembly.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  9. Install the grille. Refer to GRILLE REPLACEMENT (GMC) , GRILLE REPLACEMENT (CHEVROLET) or GRILLE REPLACEMENT (OLDSMOBILE) in Exterior Trim.
scientia non olet · About LEMON Manuals