Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Heat the weld join molding, using a heat gun J 25070 152 mm (6 in) from the surface.
Apply the heat using a circular motion for about 30 seconds.

NOTE: Refer to EXTERIOR TRIM EMBLEM REMOVAL NOTICE .
To remove the weld joint molding from the roof, begin at one end and use a small plastic flat-bladed tool. Lift the weld joint molding away from the weld joint.

Fig 1: Removing Weld Joint Molding
Courtesy of GENERAL MOTORS CORP.
Remove all adhesive from the body panel using 3M^TM Scotch Brite molding adhesive remover disk 3M^TM P/N 07501 or equivalent.
Clean the body panel using Varnish Makers and Painters (VMP) naphtha.

Fig 2: Removing Adhesive
Courtesy of GENERAL MOTORS CORP.