LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1717 (Bumpers) >> Repair Instructions >> Fascia Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  1. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Pull back the rear compartment trim panel. Refer to COMPARTMENT TRIM PANEL REPLACEMENT -- REAR .
  4. Remove the bolts from the rear bumper fascia.
    Fig 1: Rear Bumper Fascia
    G01616852Courtesy of GENERAL MOTORS CORP.
  5. Remove the nuts from the rear bumper fascia.
  6. Remove the push-in retainers from the splash shield.
  7. Remove the license lamp. Refer to LICENSE LAMP REPLACEMENT .
  8. Remove the push-in retainers from the rear bumper fascia using J 38778. 
  9. Remove the rear push-in retainers from the rear bumper fascia to the rear end panel using J 38778. 
  10. Remove the rear bumper fascia from the vehicle.
scientia non olet · About LEMON Manuals