LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1717 (Bumpers) >> Repair Instructions >> Fascia Replacement - Front Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  1. Apply tape to the corners of the hood and the adjacent surfaces.
  2. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  3. Remove the headlight assembly. Refer to HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT .
  4. Remove the fog lamps. Refer to FOG LAMP REPLACEMENT -- FRONT .
  5. Remove the push-in retainers from the front bumper fascia to radiator air baffle using J 38778. 
  6. Remove the front bumper fascia to front bumper fascia upper support center bolt.
  7. Remove the screws from the front bumper fascia to the front fender liner.
  8. Remove the bolt from the front bumper fascia to the front fender.
  9. Remove the push-in retainers from the front bumper fascia using J 38778. 
  10. Remove the front bumper fascia from the vehicle.
    Fig 1: Front Bumper Fascia
    G01616838Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals