Heating Operation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The purpose of the heater is to supply heat to the interior of the vehicle. The vehicle operator can determine the level of heat by turning the air temperature switch, located on the HVAC control module, to any setting. The air temperature switch can change the vehicle's air temperature regardless of the HVAC mode setting, heater or A/C.

When the air temperature switch is placed to the warmest position the HVAC control module will not regulate the air temperature. The HVAC control module will move the air temperature actuator to divert all air flow through the heater core. The blower speed and mode selection will be set at the last known manual input to the HVAC control module. Unless the blower motor switch is in the Auto position then the blower motor is at full speed. The HVAC control module will not monitor the sensors as the module will place the air temperature actuator to its full warm position.

When the air temperature switch is placed to any position other than the warmest position the air temperature actuator position is regulated to achieve desired temperature. This action does not place the entire HVAC system to automatic mode. When a warm air temperature is needed the HVAC control module will monitor the lower air temperature sensor, the inside air temperature assembly and the sunload sensor to correctly position the air temperature door. The HVAC control module will only change the position of air temperature actuator to get the desired temperature, blower speed and mode are not regulated.