LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Defroster Duct Replacement - Windshield >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Defroster Duct
    GM735928Courtesy of GENERAL MOTORS CORP.
  1. Install the defroster duct.
  2. Insert defroster duct into retaining slots.
  3. Fig 2: Driver Side Window Defroster Duct
    GM735890Courtesy of GENERAL MOTORS CORP.
  4. Install the driver side window defroster duct.
  5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the retaining screw (1) to the driver side window defroster duct (4).

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  7. Fig 3: Passenger Side Window Defroster Duct
    GM735924Courtesy of GENERAL MOTORS CORP.
  8. Install the passenger side window defroster duct.
  9. Install the passenger side window defroster duct (3) retaining screw (4).

    Tighten:  Tighten the nut to 2 N.m (18 lb in).

  10. Install the I/P assembly. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT in Instrument Panel, Gages and Console.