LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1709 (HVAC Systems - Troubleshooting) >> Repair Instructions >> Blower Motor Resistor Replacement - Auxiliary >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear HVAC module assembly. Refer to HVAC Module Replacement - Auxiliary .
    Fig 1: Blower Motor Control Processor-Auxiliary
    GM814581Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the blower motor control processor-auxiliary (3).
  3. Remove the screws from the blower motor control processor-auxiliary (3).
  4. Remove the blower motor control processor-auxiliary (3).
  5. Remove the thermal gasket from the evaporator core-auxiliary surface.